Volvo Penta — Draining fuel filter water separator
Maintenance
From a Volvo Penta operator's manual covering: IPS 350, IPS 450, IPS 500. Check it applies to your exact model before use.
Applies to: Volvo Penta IPS 350, Volvo Penta IPS 450, Volvo Penta IPS 500
Procedure
- Stop engine and remove starter key.
- Remove cable from water separator.
- Place receptacle under fuel filter and unscrew water separator enough to let water run out.
- Screw in water separator until it bottoms, then a further 1/4 to 1/2 turn.
- Fasten cable from water separator.
Specs & values
- Tighten water separator 1/4 to 1/2 turn after bottoming
Full service-parts list: Volvo Penta IPS 450 →
Source: Volvo Penta operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.