Volvo Penta — Alignment of drive-unit
Repair & overhaul · Steering system
From a Volvo Penta operator's manual covering: IPS 350, IPS 450, IPS 500. Check it applies to your exact model before use.
Applies to: Volvo Penta IPS 350, Volvo Penta IPS 450, Volvo Penta IPS 500
Before you start
- Carry out with engines stopped.
- Do not force crank tool beyond end position.
Procedure
- Remove plug; disconnect cable by pressing lock and wiggling connector.
- Connect switch and fit crank tool.
- Press switch button and turn crank tool carefully to end position; stop when reached.
- Turn crank tool back 75 turns; drive-unit is aligned straight forward.
- Remove crank tool, disconnect switch, fit plug, reconnect cable.
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Turn crank tool back 75 turns
Full service-parts list: Volvo Penta IPS 450 →
Source: Volvo Penta operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.