Perkins 1106C-70TA / 1106D-70TA — Engine Oil and Filter - Change

Maintenance · Lubrication System

For the Perkins 1106C-70TA / 1106D-70TA, from the Perkins operator's manual.

Applies to: Perkins 1106C-70TA, Perkins 1106D-70TA

Procedure

1. Run engine to normal operating temperature, then stop engine.
2. Drain oil via drain valve or remove oil drain plug (both ends for shallow oil pan).
3. Clean and install oil drain plugs; replace O ring seal if necessary. Tighten drain plug to 34 N·m.
4. Remove the oil filter with a suitable tool.
5. Clean the sealing surface of the oil filter base.
6. Apply clean engine oil to the O ring seal of the new oil filter.
7. Install new oil filter; rotate 3/4 of a full turn after O ring contacts sealing surface.
8. Remove oil filler cap and fill oil pan with correct amount of new engine oil.
9. Start engine and run at LOW IDLE for 2 minutes; inspect for leaks.
10. Stop engine and allow oil to drain back to oil pan for a minimum of 10 minutes.
11. Check oil level; maintain between MIN and MAX marks.

Full service-parts list: Perkins 1106C-70TA →, Perkins 1106D-70TA →

Source: Perkins operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Perkins repair guides →