Northern Lights M864 — Starting
Operation · Generator set
For the Northern Lights M864, from the Northern Lights owner's manual.
Applies to: Northern Lights M864
Before you start
- Holding the Shutdown Bypass switch too long can burn out the glow plugs.
- Excessive cranking on sets with a water lift muffler can cause engine damage.
Procedure
- Hold Shutdown Bypass switch ON for 10-20 seconds before starting.
- While holding Shutdown Bypass ON, push Engine Control switch to START.
- As soon as engine starts, release both switches.
- Do not crank starter more than 20 seconds consecutively.
- If engine fails to start, ensure it has stopped completely before re-engaging.
- If no start after 3 consecutive 20-second cranks, remove impeller from seawater pump, restart, then shut off immediately and reinstall impeller.
Specs & values
- Shutdown Bypass ON for 10-20 seconds
- Max cranking 20 seconds consecutively
Full service-parts list: Northern Lights M864 →
Source: Northern Lights owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.