Northern Lights M38CR2 / M944 — Change Lube Oil Filter
Maintenance
For the Northern Lights M38CR2 / M944, from the Northern Lights operator's manual.
Applies to: Northern Lights M38CR2, Northern Lights M944
Before you start
- Overtightening can damage filter housing.
Parts for this job
- 24-01201 Oil filter — Northern Lights M38CR2 Amazon eBay $44.99 NAPA $21.57
- 24-08001 Oil filter — Northern Lights M944 Amazon eBay $27.44 NAPA $9.09
Part numbers from the service-parts lists for Northern Lights M38CR2, Northern Lights M944. Verify against your serial number before ordering; some links are affiliate links.
Procedure
- Use filter wrench to remove old filter.
- Remove and discard old gasket; clean mounting face.
- Apply thin film of engine oil to new filter gasket.
- Screw filter on by hand until gasket meets sealing surface.
- Tighten one-half turn farther by hand only.
- Start engine, check for leaks, stop, wait 3 minutes, check oil level.
Tools required
- Filter wrench Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Oil filter part number 24-01201 Amazon eBay $44.99 NAPA $21.57.
Full service-parts list: Northern Lights M38CR2 →, Northern Lights M944 →
Source: Northern Lights operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.