MQ Power DCA-220SSV / DCA-220SSVU — 3Ø-480V UVWO Terminal Output Connection
Installation · Output terminal lugs / voltage change-over board
For the MQ Power DCA-220SSV / DCA-220SSVU, from the MQ Power operator's manual.
Applies to: MQ Power DCA-220SSV, MQ Power DCA-220SSVU, Volvo Penta TAD520GE engine, Volvo Penta TAD741GE engine
Before you start
- Never place jumper plates on the voltage change-over board while the generator is in operation.
Procedure
- Jumper the voltage change-over board for 480V operation.
- Use 6 jumper plates in 3 different positions; every jumper plate must be used.
- Connect the load wires to the UVWO terminals.
Specs & values
- 480V configuration
- 6 jumper plates in 3 positions
Full service-parts list: MQ Power DCA-220SSV →, MQ Power DCA-220SSVU →
Source: MQ Power operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.