Mitsubishi S4S-D — Removing Flywheel
Repair & overhaul
For the Mitsubishi S4S-D, from the Mitsubishi service manual.
Applies to: Mitsubishi S4S-D, Mitsubishi S4S engine
Before you start
- Be very careful not to cut your hand with the ring gear.
Procedure
- Remove one flywheel mounting bolt.
- Screw the safety rod (M12 x 1.25) into the threaded hole.
- Remove the remaining bolts and remove the lock washers.
- Hold the flywheel firmly and shake it back and forth to pull it out straight.
Tools required
- Safety rod M12 x 1.25 Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Source: Mitsubishi service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.