Mitsubishi S4S-D — Installing Cylinder Head
Installation
For the Mitsubishi S4S-D, from the Mitsubishi service manual.
Applies to: Mitsubishi S4S-D, Mitsubishi S4S engine
Before you start
- Do not use liquid packing.
- Make sure there are no dents on the top surface of the crankcase.
Procedure
- Fit the cylinder head gasket to two dowel pins on top of the crankcase.
- Install the cylinder head to fit the dowel pins.
- Tighten the cylinder head bolts evenly in the specified order.
Specs & values
- Cylinder head bolts: 113 to 123 N.m (11.5 to 12.5 kgf.m) [83.2 to 90.4 lbf.ft]
- Number of bolts: 25 (S6S), 17 (S4S)
Source: Mitsubishi service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.