Magnum MTT25 / MTT25CAN — Using the Pressurized Water Supply Bibb(s)
Operation · Water pump / hose bibbs
For the Magnum MTT25 / MTT25CAN, from the Magnum operator's manual.
Applies to: Magnum MTT25, Magnum MTT25CAN, Isuzu 4LE1NYGV-01 / 4LE1NYGV-03E engine, Isuzu 4LE1NYGV-03G / 4LE1NYGV-03E engine
Before you start
- NEVER use water in the supply tank for human consumption.
- Drain the tank when temperature is expected to drop below 32°F (0°C) or if stored for a long period.
Procedure
- Connect a hose from one of the pressure hose bibbs to the end location.
- Start the engine on the unit.
- Switch the main circuit breaker to the ON (I) position.
- Open the pressure hose bibb(s).
- Switch the pump on; it will stop automatically when the water pressure reaches 35 psi (241 kPa).
Specs & values
- Pump cut-off pressure 35 psi (241 kPa)
Source: Magnum operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.