Magnum MTT25 / MTT25CAN — Towing the Unit
Operation · Trailer
For the Magnum MTT25 / MTT25CAN, from the Magnum operator's manual.
Applies to: Magnum MTT25, Magnum MTT25CAN, Isuzu 4LE1NYGV-01 / 4LE1NYGV-03E engine, Isuzu 4LE1NYGV-03G / 4LE1NYGV-03E engine
Before you start
- Towing the unit with water in the tank will adversely affect handling of the towing vehicle.
Procedure
- Raise the four leveling jacks completely, remove the locking pins, rotate them up into the travel position, and replace the pins.
- Use the tongue jack to raise or lower the trailer onto the hitch; lock the coupling, attach safety chains or cables, and raise the tongue jack completely.
- Lube the grease fittings located on the leveling jacks.
- Connect any trailer wiring to the tow vehicle and check directional and brake lights.
- Make sure the mast cradle locking pin is in place and the doors are properly latched.
- If driven over rough ground, remove the bulbs from the light fixtures.
- Check trailer tire inflation and check the wheel lugs; tighten lugs to the specified torque in sequence.
- Re-torque the lug nuts in sequence after the first road use.
Specs & values
- Maximum recommended highway towing speed 45 mph (72 km/h)
- Off-road towing speed not to exceed 10 mph (16 km/h)
Source: Magnum operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.