Magnum MTT25 / MTT25CAN — Removing the Lights for Transportation

Operation · Lights / mast junction box

For the Magnum MTT25 / MTT25CAN, from the Magnum operator's manual.

Applies to: Magnum MTT25, Magnum MTT25CAN, Isuzu 4LE1NYGV-01 / 4LE1NYGV-03E engine, Isuzu 4LE1NYGV-03G / 4LE1NYGV-03E engine

Procedure

1. On units with quick disconnect fittings, disconnect the power cords from the junction box and replace the dust caps.
2. On hard wired units, remove the junction box cover and disconnect ONLY the mast light wires, flipping locking levers down and pulling wires out.
3. Remove the lights from the mast by removing the wing nut holding each light fixture bracket to the cross tube.
4. Attach the lights to the storage brackets (if equipped) located on the mast tube.

Source: Magnum operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Magnum repair guides →