Magnum MTT25 / MTT25CAN — Light Tower Set Up
Installation · Light tower trailer
For the Magnum MTT25 / MTT25CAN, from the Magnum operator's manual.
Applies to: Magnum MTT25, Magnum MTT25CAN, Isuzu 4LE1NYGV-01 / 4LE1NYGV-03E engine, Isuzu 4LE1NYGV-03G / 4LE1NYGV-03E engine
Before you start
- The mast extends up to 31.5 ft (9.6 m). Make sure the area above the unit is open and clear of overhead wires and obstructions.
- Do not set up the unit if high winds or storms capable of producing lightning are expected in the area.
Procedure
- For maximum light coverage, locate the unit at ground level or higher than the area being illuminated.
- Place the unit on firm ground that is relatively flat, then block the wheels to keep it from moving.
- Turn the tongue jack handle clockwise to raise the trailer tongue off the towing vehicle.
- Connect a good earthen ground to the grounding stud on the frame at the base of the mast post.
- Pull the locking pins on the four leveling jacks, rotate them foot-down, and reinsert pins; adjust until level.
- Adjust lamps by loosening the trunnion wing nuts, aim as desired, tighten hardware and ensure lamps are connected to the junction box.
Source: Magnum operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.