Magnum MTP4000S — Starting The Pump
Operation · Engine / Pump
For the Magnum MTP4000S, from the Magnum operator's manual.
Applies to: John Deere PE4024TF281 engine
Before you start
- Never adjust the pump flow by attaching a valve to the intake or outlet side of the pump
- Avoid running the intake side of the pump dry; air from the intake may cause cavitation
Procedure
- Make sure all hose couplings, covers and plugs are tight.
- Check the oil level in the sight glasses between engine flywheel and pump volute; level should be in the middle.
- Check engine oil level, coolant level and fuel level; make sure starting battery is connected.
- Make sure the Emergency Stop switch is pulled out (deactivated).
- Push the Engine Start Switch up to the MANUAL START position and wait for the PREHEAT LED to activate glow plugs.
- Allow the engine to run until it reaches a constant speed, then adjust speed with the hand throttle.
- The pump should self prime and begin to discharge within minutes; if it fails to prime within five minutes, stop and check the suction line.
Source: Magnum operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.