Magnum MLT4000S — Towing the Trailer
Operation
For the Magnum MLT4000S, from the Magnum operator's manual.
Applies to: Magnum MLT4000S, Generac GN-220 engine
Before you start
- Always transport the unit with BOTH CYLINDER VALVES CLOSED.
Procedure
- Close the cylinder valves on BOTH LP tanks.
- Raise the rear jack and outrigger jacks completely and rotate them up into the travel position; ensure locking pins snap into place.
- Release the outrigger locking pins and slide the outriggers into the trailer frame until the pins snap into place.
- Use the tongue jack to raise or lower the trailer onto the hitch; lock the coupling and attach safety chains or cables to the vehicle.
- Lube the grease fittings on the leveling jacks.
- Connect any trailer wiring to the tow vehicle and check stop and signal lights.
- Check for proper inflation of the trailer tires.
Specs & values
- Maximum tire pressure 65 psi
- Highway towing speed 45 mph (72 km/h); off-road 10 mph (16 km/h)
Full service-parts list: Magnum MLT4000S →
Source: Magnum operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.