Magnum MLT4000S — Light Tower Set Up
Installation
For the Magnum MLT4000S, from the Magnum operator's manual.
Applies to: Magnum MLT4000S, Generac GN-220 engine
Before you start
- The tower extends up to 25 ft (7.6 m). Make sure area above the trailer is open and clear of overhead wires and obstructions.
Procedure
- For maximum light coverage locate the tower at ground level or in a spot higher than the area being illuminated.
- Position the unit on a firm, non-combustible surface that is relatively flat, free of overhead obstructions and has a clear southerly view.
- Orient the unit with the trailer hitch facing north and block the wheels to keep it from moving.
- Pull the locking pin on the tongue jack, rotate it 90°, and turn the jack handle clockwise to raise the trailer tongue off the towing vehicle.
- If necessary, connect a good earthen ground to the grounding stud on the frame near the trailer tongue.
- Pull the locking pin on the outriggers and extend them until the pin snaps back in place; extend the outrigger jacks to the ground.
- Pull the locking pin on the rear jack, rotate it 90°, and turn the jack handle clockwise to level the trailer; adjust all four jacks to the ground.
Full service-parts list: Magnum MLT4000S →
Source: Magnum operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.