Magnum MLT4000S — Deploying the Solar Panels
Operation
For the Magnum MLT4000S, from the Magnum operator's manual.
Applies to: Magnum MLT4000S, Generac GN-220 engine
Before you start
- Always support the solar panels down to their resting position completely. Allowing the solar panels to drop or fall may damage the solar panels and/or tilt frame.
Procedure
- Set up the unit as described in Light Tower Set Up.
- Release the two hook clamps securing the solar panels together on both sides of the unit.
- Rotate the top/front solar panel forward to the tilt frame and secure it using the twist lock clamps.
- Rotate the bottom/rear solar panel backward to the horizontal position until the rubber bumpers contact the center panel.
- Use the solar alignment guide or setup decal to calculate the optimal panel angle.
- Raise the solar panels using the Panel Angle switch until the desired angle is reached; use the Angle Indicator to determine the angle.
Full service-parts list: Magnum MLT4000S →
Source: Magnum operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.