Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Magnum›Light Tower Set Up

Magnum MLT3060 — Light Tower Set Up

Installation · Mast/Trailer

For the Magnum MLT3060, from the Magnum operator's manual.

Applies to: Magnum MLT3060, Kubota D1005-E3BG1-MGM-1 engine

Before you start

  • Do not set up if high winds or lightning storms are expected

Procedure

  1. Locate unit at ground level or higher than area to be illuminated.
  2. Place unit on firm, flat ground and block wheels.
  3. Pull locking pin, rotate tongue jack 90°, replace pin, raise tongue off tow vehicle.
  4. Connect earthen ground to grounding stud at base of mast post.
  5. Extend outriggers until locking pins snap into place; rotate outrigger jacks down.
  6. Rotate and lock rear jack; level trailer by turning all four jack handles clockwise.
  7. Adjust lamp aim by loosening trunnion wing nuts, then tighten and connect to junction box.

Full service-parts list: Magnum MLT3060 →, Kubota D1005-E3BG1-MGM-1 engine →

Source: Magnum operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Magnum repair guides →