Home›Repair guides›Kohler›Starting

Kohler — Starting

Operation · engine

From a Kohler owner's manual covering: TP 3.0, WP 2.0, WP 3.0. Check it applies to your exact model before use.

Applies to: Kohler TP 3.0, Kohler WP 2.0, Kohler WP 3.0

Before you start

  • Carbon Monoxide can cause severe nausea, fainting or death.
  • Rotating parts can cause severe injury. Stay away during operation.
  • Never operate pump without priming water.

Procedure

  1. Immerse suction strainer completely in liquid being pumped.
  2. Fill pump body with water via discharge port or filler cap.
  3. Connect discharge and suction couplings.
  4. Turn fuel shut-off valve to ON position if equipped.
  5. Turn engine on/off switch to ON position if equipped.
  6. Place throttle lever midway between SLOW and FAST.
  7. Place choke lever into ON position for cold engine.
  8. Slowly pull recoil starter handle until compression-STOP.
  9. Return recoil starter handle; firmly pull straight out.
  10. Gradually return choke lever to OFF after engine warms.

Tools required

Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.

Full service-parts list: Kohler TP 3.0 →, Kohler WP 2.0 →, Kohler WP 3.0 →

Source: Kohler owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Kohler repair guides →