Kohler — Microswitch Replacement (100/200 Amp Models)
Repair & overhaul · Microswitch (Normal or Emergency source coil)
From a Kohler service manual — check it applies to your exact model before use.
Browse Kohler generators & specs →
Procedure
- Loosen the four coil mounting screws (two per coil) by two full rotations; do not remove the coils.
- Remove the microswitch mounting screw and microswitch.
- Install the new microswitch; push the mounting screw in the direction of the arrow and tighten to 0.44 Nm (4 in. lb.).
- Tighten the four coil mounting screws.
Tools required
- Basic hand tools
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Microswitch mounting screw 0.44 Nm (4 in. lb.)
Source: Kohler service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.