Kohler — Manual Operation Procedure 1
Operation · Transfer switch contactor (100-200 amp single-phase, 400 amp single-phase and 208-240V)
From a Kohler service manual — check it applies to your exact model before use.
Browse Kohler generators & specs →
Before you start
- Never manually operate the transfer switch when the power is connected. Disconnect both power sources before manually operating the switch.
Procedure
- 100-200 amp switches have an attached handle; 400 amp switches: slide the detachable handle or a wrench over the shaft.
- Move the handle up to place the transfer switch in the Normal Source position, or down for the Emergency Source position.
- 400 amp switches: remove the detachable handle or wrench.
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Source: Kohler service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.