Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Check the oil level. Note if the oil level is within

Kohler — Check the oil level. Note if the oil level is within

For these Kohler models: CV11-16, CV460-465, CV490-495.

Applies to: Kohler Cv460 465, Kohler Cv490 495

Before you start

  • away from the workbench. Be sure to
  • It is good practice to drain oil at a location
  • allow ample time for complete drainage.

Procedure

  1. 2
  2. Insert the rubber stopper into the oil fill hole. Be
  3. Start the engine and run at no-load, high
  4. Open the clamp and note the water level in
  5. 2 cm (4 in.) above the level in the open side.
  6. Close the shut-off clamp before stopping
  7. Crankcase breather clogged or inoperative.
  8. Disassemble breather, clean parts thoroughly,

Tools required

  • the barbed gauge fitting into the hole in the
  • gauge reading. Needle movement to the left of
  • gauge, insert the stopper as in step 1. Insert
  • manometer or vacuum/pressure test gauge. See
  • can be accurately inspected and gauged for wear
  • stopper. Be sure the gauge needle is at "0".

Source: manual:CV Single.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.