Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Service Procedure

Kohler — Service Procedure

For these Kohler models: CV11-16, CV460-465, CV490-495.

Applies to: Kohler Cv460 465, Kohler Cv490 495

Procedure

  1. Run engine for 3-5 minutes to warm it up.
  2. Remove spark plug(s) and air filter from
  3. Rotate the crankshaft until the piston is at top
  4. Install the adapter into the spark plug hole, but
  5. Connect an adequate air source to the tester.
  6. Turn the regulator knob in the increase (clockwise)
  7. Connect
  8. Check your test results against the table below:

Source: manual:CV Single.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.