Isuzu 4LE2 — Engine Starting
Operation
For the Isuzu 4LE2, from the Isuzu owner's manual.
Applies to: Isuzu 4LE2, Isuzu 4LE2 engine
Before you start
- Do not use starting aids in the air intake system
Procedure
- Make sure all hydraulic control levers on the equipment are in NEUTRAL.
- Set the engine stop knob in the START position.
- Switch ON the battery switch (if so equipped).
- Insert the starter switch key and turn clockwise to DRIVE position.
- Pre-heat the engine (QOS type or control resistance type) until the indicator goes out or coil becomes red.
- Depress the throttle lever/pedal and turn the key to START position.
Specs & values
- Cranking period must not exceed ten seconds
Full service-parts list: Isuzu 4LE2 →, Isuzu 4LE2 engine →
Source: Isuzu owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.