Isuzu 4LE2 — Application procedure for liquid gasket
Maintenance · Liquid gasket joints
For the Isuzu 4LE2, from the Isuzu service manual.
Applies to: Isuzu 4LE2, Isuzu 4LE2 engine
Before you start
- Use the correct quantity of liquid gasket; always follow the handling instructions for each product.
- Do not use gasket remover (Pando-391D) on resin components or painted components.
Procedure
- Wipe the contact surfaces clean of all water, oil or grease. The contact surfaces should be dry.
- Apply a regular bead width of liquid gasket to one of the contact surfaces. Make sure that the bead does not break at this point.
- If there are special regulations concerning the application procedure in the repair document, follow those regulations.
Specs & values
- Re-install parts within 5 minutes of applying the liquid gasket
- Wait at least 30 minutes after the last part is installed before starting the engine
Full service-parts list: Isuzu 4LE2 →, Isuzu 4LE2 engine →
Source: Isuzu service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.