Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Honda›Starting the engine

Honda EB3000 / EB4000 — Starting the engine

Operation

For the Honda EB3000 / EB4000, from the Honda owner's manual.

Applies to: Honda EB3000, Honda EB4000, Honda GE300 engine, Honda GE400 engine

Before you start

  • Do not allow the starter grip to snap back. Return it slowly by hand.

Procedure

  1. Turn the fuel valve on.
  2. Pull the choke rod to CLOSE.
  3. Make sure the auto-throttle switch is off (or more time will be required for warm up).
  4. Turn the engine switch on.
  5. Pull the starter grip until compression is felt, then pull briskly.
  6. Push the choke rod to OPEN as the engine warms up.
  7. If auto-throttle will be used, turn the switch to AUTO after the engine has warmed up.

Source: Honda owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Honda repair guides →