Home›Repair guides›Generac›Towing the Unit

Generac — Towing the Unit

Operation · Jacks, outriggers, hitch and trailer lights

From a Generac owner's manual covering: MLT5150, MLT5200, MLT5200ICAN. Check it applies to your exact model before use.

Applies to: Generac MLT, Mitsubishi S4L2-W461ML engine, Isuzu 4LE1NYGV-03 / 4LE1NYGV-03E engine, Isuzu D1105-E3BG engine

Before you start

  • Property or Equipment Damage. Tighten wheel lug nuts after first 50 miles to factory specifications.
  • Trailer must be securely coupled to the hitch and the chains correctly attached. Uncoupled or unchained towing could result in death or serious injury.

Procedure

  1. Raise the rear jack completely and release the locking pin to rotate it up into the travel position; verify the pin snaps into place.
  2. Raise the outrigger jacks completely, release the jack locking pins to swing the jacks up, and slide the outriggers into the trailer frame until their pins snap into place.
  3. Use the tongue jack to raise or lower the trailer onto the hitch; lock the hitch coupling and attach safety chains or cables.
  4. Remove the jack locking pin and rotate the jack into the travel position; replace the locking pin.
  5. Lubricate the grease fittings located on the leveling jacks.
  6. Connect trailer wiring to the tow vehicle and check operation of directional and brake lights.
  7. Verify the enclosure is properly latched and the mast cradle lock is in place.
  8. Verify the doors are properly latched.
  9. If driving over rough ground, remove the bulbs from the light fixtures.
  10. Check for proper inflation of the trailer tires.
  11. Check the wheel lugs and tighten or replace any that are loose or missing using the three-pass torque sequence.

Tools required

Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.

Specs & values

  • First pass: 20-25 FridayParts $42.95 ft-lbs (27-33 Nm)
  • Second pass: 50-60 FridayParts $15.68 ft-lbs (67-81 Nm)
  • Third pass: 90-120 FridayParts $377.99 ft-lbs (122-162 Nm)
  • Maximum recommended highway towing speed 45 mph (72 km/h)
  • Off-road towing speed not to exceed 10 mph (16 km/h)

Full service-parts list: Generac MLT →, Mitsubishi S4L2-W461ML engine →, Isuzu 4LE1NYGV-03 / 4LE1NYGV-03E engine →

Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Generac repair guides →