Generac — Throttle Linkage Adjustment
Adjustments · throttle linkage / governor
From a Generac owner's manual covering: IMPACT 36, IMPACT-34 plus, Impact-36 plus. Check it applies to your exact model before use.
Applies to: Generac Impact-36 plus, Generac GN-220 engine
Before you start
- Do not overbend the spring clip or it will lose its clamping force
Procedure
- Start generator, then shut it down right away and observe throttle lever rotate counterclockwise as engine coasts to stop
- Verify gap of 0.003 inch (0.08-0.5mm) between stop tab on throttle lever arm and stop block on carburetor die casting
- With pliers, lightly compress spring clip on carburetor lever arm to allow linkage rod to slide freely
- Rotate throttle lever to adjust gap to 0.003 inch clearance
- Release spring clip to secure adjustment
Tools required
- pliers Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- gap 0.003 inch (0.08-0.5mm)
Full service-parts list: Generac Impact-36 plus →
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.