Generac — Test 4 – Test DC Circuit Breaker
Testing & diagnosis
From a Generac service manual covering: iX 1600, iX 2000, iX 800. Check it applies to your exact model before use.
Applies to: Generac iX 1600, Generac iX 2000, Generac iX 800
Procedure
- Remove the electrical panel so that the DC circuit breaker is exposed and remove both wires from the breaker.
- Ensure that the breaker is reset and not tripped.
- Set VOM to measure resistance.
- Connect meter leads across the breaker and measure resistance. CONTINUITY should be measured.
Tools required
- VOM Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- CONTINUITY
Full service-parts list: Generac iX 1600 →, Generac iX 2000 →, Generac iX 800 →
Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.