Generac — Retransfer and Shutdown (Manual Transfer Switch)
Operation · Generator and manual transfer switch
From a Generac owner's manual — check it applies to your exact model before use.
Applies to: Generac In Line engine
Procedure
- Set the standby generator's main line circuit breaker to its OFF (or OPEN) position.
- Manually move the transfer switch handle to its UTILITY (NORMAL) position.
- Turn ON the utility power supply to the transfer switch.
- Let the generator run at no-load for a few minutes to stabilize internal temperatures.
- Shut down the generator.
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.