Generac — Replacing the AVR Filter
Maintenance
From a Generac owner's manual — check it applies to your exact model before use.
Applies to: Generac 15 kW EcoGen, Generac G-Force 1000 Series engine
Before you start
- AVR maintains electrical charge after shutdown; wait 5 minutes before removal
Procedure
- Remove screw to release AVR filter housing from back panel
- Remove AVR filter housing
- Grasp rubber lifting strap and remove filter from housing
- Install new filter positioned inboard of two tabs
- Install AVR filter housing, torque screw to 50-96 in-lbs (6-11 Nm)
Specs & values
- Screw torque 50-96 in-lbs (6-11 Nm)
Full service-parts list: Generac 15 kW EcoGen →
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.