Generac — Removing the Lights for Transportation
Operation · Light fixtures and junction box
From a Generac owner's manual covering: MLT5150, MLT5200, MLT5200ICAN. Check it applies to your exact model before use.
Applies to: Generac MLT, Mitsubishi S4L2-W461ML engine, Isuzu 4LE1NYGV-03 / 4LE1NYGV-03E engine, Isuzu D1105-E3BG engine
Procedure
- Disconnect the power cords from the junction box at the top of the mast.
- Install the dust caps on the junction box.
- Remove the lights from the mast by removing the wing nut that holds the light fixture bracket to the cross tube.
- Insert the lights onto the light storage channel located on the inside of each door.
- Orient the lights so the lenses are facing the rubber seal on the inside of the door.
- Secure the light fixtures with the wing nuts and secure the light cords to prevent damage.
Specs & values
- Verify the star washer is in place between the trunnion and T-handle before tightening
Full service-parts list: Generac MLT →, Mitsubishi S4L2-W461ML engine →, Isuzu 4LE1NYGV-03 / 4LE1NYGV-03E engine →
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.