Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Generac›Starting the Generator

Generac QuietPact 40 — Starting the Generator

Operation

For the Generac QuietPact 40, from the Generac owner's manual.

Applies to: Generac QuietPact 40, Generac GN-220 engine

Before you start

  • Holding the switch longer than 15 seconds can damage the starter motor.

Procedure

  1. Turn OFF electrical loads using the means provided in your vehicle (main circuit breaker or transfer switch).
  2. If not started in more than two weeks, press the Fuel Pump Primer switch and hold about 10 to 15 seconds.
  3. Hold the engine Start/Stop switch in the START position to crank. Release when engine starts.
  4. Let the engine run at no-load for a few minutes to stabilize and warm up.
  5. Turn ON electrical loads using the means provided.

Specs & values

  • Do not crank longer than 15 seconds

Full service-parts list: Generac QuietPact 40 →

Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Generac repair guides →