Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Generac›Starting the Generator

Generac QuietPact 40 LP — Starting the Generator

Operation

For the Generac QuietPact 40 LP, from the Generac owner's manual.

Applies to: Generac QuietPact 40 LP, Generac GN-220 engine

Before you start

  • Holding the Start/Stop switch for longer than 15 seconds can damage the starter motor.

Procedure

  1. Turn OFF electrical loads using the vehicle's main line circuit breaker or transfer switch.
  2. If engine has not been started in more than two weeks, press the Fuel Pump Primer switch and hold about 10 to 15 seconds.
  3. Hold the engine Start/Stop switch in the START position to crank the engine. Release when engine starts.
  4. If engine does not start after 15 seconds cranking, release switch, wait one minute and try again.
  5. Let the engine run at no-load for a few minutes to stabilize and warm up.
  6. Turn ON electrical loads using the means provided (main circuit breaker or transfer switch).

Full service-parts list: Generac QuietPact 40 LP →

Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Generac repair guides →