Generac Q-70G — Stopping the Generator

Operation · Generator control panel

For the Generac Q-70G, from the Generac owner's manual.

Applies to: Generac GN-480 engine

Procedure

1. Turn OFF all electrical loads using the means provided (such as a main circuit breaker or transfer switch).
2. Let generator run at no-load for a few minutes to stabilize internal engine and generator temperatures.
3. Place the Start/Stop switch in its STOP position.

Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Generac repair guides →