Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Generac›Checking the Engine Oil Level

Generac Q-70G — Checking the Engine Oil Level

Maintenance · Engine crankcase

For the Generac Q-70G, from the Generac owner's manual.

Applies to: Generac GN-480 engine

Before you start

  • Never operate the engine with the oil level below the "Add" mark on the dipstick.
  • DO NOT FILL ABOVE THE "FULL" MARK.

Procedure

  1. Be sure the generator is as level as possible.
  2. Remove the dipstick and wipe it dry with a clean, lint-free cloth.
  3. Install and tighten the dipstick cap; then remove it again. Oil level should be at the dipstick "Full" mark.
  4. If necessary, remove the oil fill cap on the rocker cover and slowly add oil until it reaches the "Full" mark.
  5. Install and tighten the oil fill cap and the dipstick before operating the engine.

Specs & values

  • Oil level at dipstick "Full" mark
  • Crankcase capacity about 1.4 liters

Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Generac repair guides →