Generac PRIMEPACT 50 / PrimePact 50 LP — Stopping the Generator

Operation · Generator control panel

For the Generac PRIMEPACT 50 / PrimePact 50 LP, from the Generac owner's manual.

Applies to: Generac GN-410 engine

Procedure

1. Turn OFF all electrical loads using the means provided.
2. Let the generator run at no-load for a few minutes to stabilize internal temperatures.
3. Place the Start/Stop switch in its STOP position.

Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Generac repair guides →