Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Generac›Starting the Generator

Generac PRIMEPACT 50 / PrimePact 50 LP — Starting the Generator

Operation · Generator control panel

For the Generac PRIMEPACT 50 / PrimePact 50 LP, from the Generac owner's manual.

Applies to: Generac GN-410 engine

Before you start

  • If the engine does not start after cranking for 15 seconds, release the Start/Stop switch and try again. Holding the switch longer than 15 seconds can damage the starter motor.

Procedure

  1. Turn OFF electrical loads using the means provided (main breaker or transfer switch).
  2. If engine has not been started in more than two weeks, press Fuel Pump Primer switch 10 to 15 seconds (gasoline only).
  3. Hold the Start/Stop switch in the START position to crank; release when engine starts.
  4. Let the engine run at no-load for a few minutes to stabilize and warm up.
  5. Turn ON electrical loads using the means provided.

Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Generac repair guides →