Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Generac›Connecting Battery Cables

Generac PRIMEPACT 50 / PrimePact 50 LP — Connecting Battery Cables

Installation · Battery / starter contactor

For the Generac PRIMEPACT 50 / PrimePact 50 LP, from the Generac owner's manual.

Applies to: Generac GN-410 engine

Before you start

  • Check that the battery cable boot for the starter cable has been installed.

Procedure

  1. Connect the cable from the POSITIVE battery post to the lug on the starter contactor.
  2. Connect the cable from the NEGATIVE battery post to the frame ground connection.
  3. Connect cables so the connectors are clean and tight.

Specs & values

  • Voltage drop should not exceed 0.12 volts per 100 amperes of cranking current

Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Generac repair guides →