Generac PRIMEPACT 50 / PrimePact 50 LP — Checking the Engine Spark Plug
Maintenance
For the Generac PRIMEPACT 50 / PrimePact 50 LP, from the Generac owner's manual.
Applies to: Generac GN-410 engine
Before you start
- Do not blast the spark plug to clean.
Procedure
- Clean the area around the base of the spark plug to keep dirt out of the engine.
- Remove the spark plug and check its condition; replace if worn or questionable.
- Check the spark plug gap with a wire feeler gauge.
- Adjust the gap to 0.030 inch (0.76 mm) by bending the ground electrode.
Tools required
- Wire feeler gauge Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Spark plug gap 0.030 inch (0.76 mm)
- Every 100 hours of operation
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.