Generac PRIMEPACT 50 / PrimePact 50 LP — Battery Cable Connections
Installation
For the Generac PRIMEPACT 50 / PrimePact 50 LP, from the Generac owner's manual.
Applies to: Generac GN-410 engine
Before you start
- Damage will result if the battery connections are made in reverse.
Procedure
- Connect battery cable from the POSITIVE (+, POS) post to the lug on the starter contactor.
- Connect battery cable from the NEGATIVE (-, NEG) post to the frame ground connection.
- Connect cables so the connectors are clean and tight.
Specs & values
- Voltage drop between battery terminals and generator connection point should not exceed 0.12 volts per 100 amperes of cranking current
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.