Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Generac›Checking the Engine Spark Plug

Generac PRIMEPACT 50 — Checking the Engine Spark Plug

Maintenance

For the Generac PRIMEPACT 50, from the Generac owner's manual.

Applies to: Generac GN-410 engine

Before you start

  • Do not blast the spark plug to clean.
  • Re-form the wire terminal for a tight fit if needed.

Procedure

  1. Clean the area around the base of the spark plug to keep dirt and debris out of the engine.
  2. Remove the spark plug and check its condition; replace if worn or if reuse is questionable.
  3. Check the spark plug gap using a wire feeler gauge.
  4. Adjust the gap to 0.030 inch (0.76 mm) by carefully bending the ground electrode.

Tools required

Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.

Specs & values

  • Spark plug gap 0.030 inch (0.76 mm)
  • Clean and reset gap every 100 hours

Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Generac repair guides →