Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Generac›Battery Cable Connections

Generac PRIMEPACT 50 — Battery Cable Connections

Installation

For the Generac PRIMEPACT 50, from the Generac owner's manual.

Applies to: Generac GN-410 engine

Before you start

  • Check to be sure the battery cable boot for the starter cable has been installed.
  • Damage will result if the battery connections are made in reverse.

Procedure

  1. Connect the battery cable from the POSITIVE, POS or (+) battery post to the lug on the starter contactor.
  2. Connect the battery cable from the NEGATIVE, NEG or (-) battery post to the frame ground connection.
  3. Connect cables so the connectors are clean and tight.

Specs & values

  • Voltage drop should not exceed 0.12 volts per 100 amperes of cranking current
  • Generators rated about 100 DC amperes of cranking current

Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Generac repair guides →