Generac PowerPact 5.6 kVA 50 Hz — Test 13 - Check and Adjust Engine Governor (CorePower)
Adjustments
For the Generac PowerPact 5.6 kVA 50 Hz, from the Generac service manual.
Applies to: Generac PowerPact 5.6 kVA 50 Hz
Procedure
- Cycle throttle to confirm throttle rod and anti-lash spring move freely.
- Loosen the governor clamp bolt (13 mm).
- Hold governor lever wide open; rotate governor shaft clockwise fully.
- Tighten governor lever clamp bolt to 70 in-lbs (8 Nm).
- Connect a frequency meter across the AC output leads (MLCB).
- Start the generator and warm up at no-load.
- Turn the adjust nut to obtain a frequency reading of 62.5 Hz.
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Governor lever clamp bolt 70 in-lbs (8 Nm)
- Frequency 62.5 Hz
Full service-parts list: Generac PowerPact 5.6 kVA 50 Hz →
Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.