Generac PowerPact 5.6 kVA 50 Hz — Reconfigure the Fuel System
Maintenance · Fuel throttle assembly
For the Generac PowerPact 5.6 kVA 50 Hz, from the Generac service manual.
Applies to: Generac PowerPact 5.6 kVA 50 Hz
Procedure
- Locate fuel throttle assembly mounted to engine intake.
- Remove hose clamp and hose from throttle assembly.
- Remove Natural Gas (larger ID) fuel jet from fuel inlet.
- Obtain the Propane fuel jet (smaller ID) supplied loose.
- Verify the O-ring is installed in the fuel jet groove.
- Insert the Propane fuel jet into the end of the fuel inlet.
- Reinstall hose and clamp onto fuel inlet and secure.
- Verify the hose has not been kinked in any way.
Tools required
- needle nose pliers Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Full service-parts list: Generac PowerPact 5.6 kVA 50 Hz →
Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.