Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Generac›Starting the Generator

Generac NP-50G — Starting the Generator

Operation

For the Generac NP-50G, from the Generac owner's manual.

Applies to: Generac NP-50G, Generac GN-410 engine

Before you start

  • If engine does not start after cranking 15 seconds, release switch and try again

Procedure

  1. Turn OFF electrical loads using means provided in vehicle.
  2. If not started in more than two weeks, press Fuel Pump Primer switch about 30 seconds.
  3. Hold engine Start/Stop Switch at START to crank engine.
  4. Release the switch when the engine starts.
  5. Let engine run at no-load a few minutes to stabilize and warm up.
  6. Turn ON electrical loads.

Full service-parts list: Generac NP-50G →

Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Generac repair guides →