Generac MLT6 — Starting the Unit (Key Switch Models)
Operation · Engine
For the Generac MLT6, from the Generac owner's manual.
Applies to: Generac MLT6, Mitsubishi L3E engine, Kubota D1005 engine
Before you start
- Do not continuously crank engine for more than ten seconds
Procedure
- Verify main circuit breaker and light breaker are OFF
- Turn key to GLOW PLUG position, hold 5 sec (15 sec max)
- Turn key to START position, hold (10 sec max) until engine starts
- Release key; it moves to RUN position
Full service-parts list: Generac MLT6 →, Kubota D1005 engine →
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.