Generac MLT3060K / MLT3060M — Trailer Wheel Bearings
Maintenance · Axle hub / wheel bearings
For the Generac MLT3060K / MLT3060M, from the Generac owner's manual.
Applies to: Generac MLT3060K, Generac MLT3060M, Mitsubishi L3E engine, Kubota D1005 engine
Before you start
- Use only a high quality grease made specifically for lubrication of wheel bearings.
Procedure
- Remove the small rubber plug on the grease cap.
- Attach a standard grease gun fitting to the grease zerk fitting.
- Pump grease into the fitting until new grease is visible around the nozzle.
- Wipe excess grease from the hub and replace the rubber plug.
Tools required
- grease gun Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Lubricate every 12 months or 12,000 miles (19,312 km)
Full service-parts list: Generac MLT3060K →, Generac MLT3060M →, Kubota D1005 engine →
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.