Generac MLT3060K / MLT3060M — Lowering the Mast—Manually
Repair & overhaul · Winch motor assembly
For the Generac MLT3060K / MLT3060M, from the Generac owner's manual.
Applies to: Generac MLT3060K, Generac MLT3060M, Mitsubishi L3E engine, Kubota D1005 engine
Before you start
- Do not use this procedure unless absolutely necessary; continuous use could damage the planetary gear brake.
Procedure
- Remove the power cables from the two terminals on the winch motor assembly.
- Remove the two flange head screws securing the winch motor assembly to the winch.
- Carefully remove the motor assembly, keeping the two pieces together.
- Insert a 3/8 in allen head wrench into the sleeve bearing.
- Rotate the wrench counterclockwise to lower the mast; stop if slack is observed.
- Install the winch motor assembly, securing it with the screws.
Tools required
- 3/8 in allen head wrench Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Full service-parts list: Generac MLT3060K →, Generac MLT3060M →, Kubota D1005 engine →
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.