Generac MDG100DF4 / MDG75DF4 — Check Generator Drive Plate Torque
Maintenance
For the Generac MDG100DF4 / MDG75DF4, from the Generac owner's manual.
Applies to: Generac MDG100DF4, Generac MDG75DF4
Procedure
- Disconnect battery.
- Remove generator fan guard.
- Tighten each of the drive plate bolts to 40 ft-lb (54 Nm).
- Install generator fan guard.
- Connect battery.
Tools required
- torque wrench Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- 40 ft-lb (54 Nm)
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.