Generac Impact-36G / NP-36G — Starting the Generator
Operation · Generator control panel
For the Generac Impact-36G / NP-36G, from the Generac owner's manual.
Applies to: Generac GN-220 engine
Before you start
- If engine does not start after 15 seconds cranking, release switch and try again
Procedure
- Turn OFF electrical loads at main breaker or transfer switch.
- Press fuel primer switch if initial startup or after extended storage.
- Hold start/stop switch at START; release when engine starts.
- Let engine run at no-load a few minutes to warm up.
- Turn ON electrical loads.
Specs & values
- Do not crank longer than 15 seconds
- Hold starter switch a minimum of 2 seconds to energize field boost
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.